• Filtration devices
• Swimming pool installation elements
• Swimming pool heating
• Water massage devices
• Water surface covering devices
• Chemical compounds and accessories
• Instructions

Steel heat exchanger
Manufactured from stainless steel. Water connections from the stove in the form of 3/4" or 1". Filtrating installation connections with application of metal-PCV connectors.

power - 90/70 degrees	power - 60/40 degrees
40 kW	28 kW
70 kW	31 kW

 

Electric water heater with a thermostat
Manufactured from steel type 1.4501. Heating element is made up of special heating bars. The set includes a thermostat devices used in the process of setting of the proper temperature of the pool water between 0 and 40 degrees C, safety thermostat device, water sensor. Swimming pool installation connection 11/2". Voltage 400 V.

Electric water heater 6 kW, 10 A

Electric water heater 9 kW, 16 A

Electric water heater 12 kW, 25 A

Electric water heater 15 kW, 30 A

Electric water heater 18 kW, 35 A

Flow sensor (for protection of the heater prior to the initiation if there is no water pressure)

 

Swimming pool collecting device

Simple and inexpensive sun collector manufactured from UV resistant polypropylene. The device may b assembled permanently on roof and remain there through the winter with no water. The maximum possible installation amounts to 4 collectors. The provided set includes: - 2 mats of the following sizes 61 x 600 cm = 122 x 600 cm - 10 steel frames - 4 rubber muffs. Collector surface: 7,4 m2 Weight without water: 18 kg. For each set (2, 61 x 600 cm mats) there should be assembled a pump of the minimum efficiency in the amount of 7 m3/h with the resistance factor H = 7 m. For 2-4 sets the pump possessing the following characteristics should be assembled: 12 m3 /h with the resistance equal to H = 9 m.

 

Swimming pool heat pumps

Swimming pool air-water type heat pumps collect the scattered solar energy from the air and change it into usable energy. Pump power depends on the outside temperature and the highest efficiency coefficient is reached at the temperature of up to +15°C. Heat pump is a efficient solution from the cost point of view at the temperature of -5°C. In order to retain the necessary water temperature it is necessary to use a pump driver. The default driver setting allows for reaching of swimming pool water temperature of +27°C with application of the following conditions: - heating – outside air temperature 24°C/19°C, - cooling – outside air temperature 35°C/24°C. There exists a possibility to programme the driver by the user in order to achieve the required temperature.